LP-102



As the LP prefix implies low profile, the LP102 simply goes where others can not.  The low travel height is achieved by a special ladder and low profile chassis working together.

Our chassis options for the LP102 are the Igniter and Inferno chassis.

Our extruded aluminum body can be supplied with or without a water pump.  Our EZ Stack design which permits hosebed reloading without the need to move the aerial is also available on this model. 

Body compartment doors can be roll up or plate style.If your conditions have more clearance, you could use a standard height cab with the LP102 ladder.

Standard Aerial Features

  • The four-section aerial ladder is constructed from 70,000-PSI yield strength steel.
  • 250#  rating at any elevation, full extension, while flowing water at 1250 GPM.
  • 500# rating when not flowing water, any elevation, full extension.
  • Rungs are sheathed with heavy-duty, serrated rubber that is bonded and clamped for the ultimate in traction, even in icy conditions.
  • Night and smoke operations are improved with ladder section LED lights for climbing areas.
  • Standard deceleration feature slows the aerial's speed when the approaching full elevation.
  • A heavy-duty replaceable egress section at the end of the aerial allows the most vulnerable part of the ladder to be replaced inexpensively if damage shall occur. The egress is also angled down 11 degrees making it easy to climb off the end of the ladder when necessary.It is painted with high visibility yellow for tip identification. 
  • Rescue eyelets, with a combined 500 pound rating, are located at the end of the fly section.
  • Both sets of rotation bearing bolts can be torqued from the top, saving time and labor during maintenance. 
  • The load sensing system provides load status in real time taking into consideration factors such as ice build up during inclement weather conditions.
  • A standard collision avoidance system limits the movement of the aerial at low angles to prevent accidental damage to the cab or body.
  • A retraction safety system, designed to minimize chances of injury in the event the aerial is moved with an occupant at the tip, is a standard safety feature.
  • The chrome plated steel waterway is more durable than an aluminum waterway which is prone to scouring.  We back this performance with an industry leading 10 year waterway pipe and seal warranty. 
  • Waterway is rated at 1250 GPM with the nozzle 90 degrees to the centerline for a total of 180 degrees side sweep.
  • Akron, Elkhart and TFT monitors available
  • Extension tubes, down tubes, inside jack housings and bottom plates are galvanized for longer expected life.
  • High visibility lightweight poly stabilizer pads provide maximum footing and stability.

Aerial Options

  • Positional waterway with electric actuator allows the operator to locate the waterwayat the tip or third section without leaving the turntable control console or manually moving a pin. 
  • 110 volt tip receptacle
  • 110 volt quartz lights
  • Tip locator lights
  • Axe bracket at tip
  • Pike at tip
  • Three with option for head set integration
  • Remote control operation for tip nozzle and aerial ladder controls
  • Fly section ladder control station for ladder movements
  • Rope pulley system for rescue work
  • Pre-wire for headsets at the turntable
  • Breathing air systems with optional turntable connections
Overall Height 10'10" (when using Inferno or Igniter Lo-Cab)
Overall Length 41' 6"
Overall Width 102"    (excluding mirrors and handrails)
Wheelbase 240"
NFPA 1901 Horizontal Reach 100' at 0 degrees
NFPA 1901 Vertical Reach 102' at 72 degrees results in more side reach
Stabilizer Spread 18'
Turning Radius 40.89' bumper swing with 21" extension
  • Standard 20-year structural warranty
  • Standard 10-year waterway warranty, including seals.
  • Standard 20-year internal corrosion warranty